Art-Tech Diamond 1000, Инструкция по эксплуатации

Страница: 13 / 17

11
1. Battery is not fully charged.
2. The battery in the transmitter
is not full.
3. The electronics have been
damaged due to a crash.
1. Charge the battery.
2. Install new dry cells.
3. Maintain or contact the local
distributor for help.
Elevator and / or Ailerons are
out of trim
Adjust the trim switch of the
appropriate control to correct.
Limited control range
1. The battery is not fully charged.
2. Elevator not set correctly
1. The batteries are almost flat 1. Install new batteries
WWW.ART-TECH.COM
4. The up and down movement of the right stick of transmitter controls the movement of the elevator.
When you pull the stick back, the elevator of plane will lift and vice versa when you push the stick forward.
The best state before flying is the elevator sticks and trim are all in the neutral position.
5. The left stick on transmitter controls the rudder when you push the stick to the right, the rudder of
plane will turn right and vice versa when the stick is pushed left. The rudder stick and trim should be neutral
before flying.
6. If the servos and motor give no response during setup, please check all connections and make sure the
battery is fully charged and the transmitter and receiver are bound together.
7. Check the CoG of the model. The proper CoG position should be 35 ~ 45 mm away from the leading edge,
please refer to the picture. If in any doubt contact your dealer.
Note: The transmitter and receiver must be the same 2.4GHz protocol. Unmatched sets will not be
compatible and may cause loss of control.
35
~
45mm
(Location of CoG)
TROUBLESHOOTING
Symptom
Model won’t fly straight
Motor will not run
Model will not climb
Causes
Solutions
1. Charge the battery
2. Re-trim the elevator