11
Setting Chime Mode
Your installer may have designated certain burglary zones to briefly
activate the mini-sounder contained in each keypad. These zones
typically annunciate that a door has been opened or closed while the
panel is in the disarmed mode.
To turn the
Chime feature
On" use the key sequence shown
below.
Enter the sequence again to turn the feature "Off".
Fault Condition
A Fault Condition could, if unheeded, potentially render your system
inactive. If such a fault should occur it will be indicated by a flashing
green READY light, a TROUBLE message on the LCD display, and
an audible warning tone at the keypad. The LED keypad indicates this
Fault condition with the "STATUS" LED flashing with the audible tone.
To identify the nature of the Fault Condition, press and HOLD the
ENTER key. This will also silence the audible warning. Fault
conditions will show on the LED or LCD displays. The LED display
will indicate the trouble condition by flashing the appropriate zone
LED (see following chart). The LCD display will now indicate the
nature of the problem and it will scroll through the problems if there
are more than one. Discuss with your installer what action to take if
a problem should occur. If a trouble condition occurs on a fire zone,
call your installer for service since an important part of your system
is out of order.
The Table on the next page shows the LCD keypad messages and the
LED Zone numbers 1-4 for each of the Fault Conditions: