Arrow 697.68617, Руководство пользователя и инструкции по сборке

Страница: 28 / 32

1
Install a left roof panel at the left
rear and right front corner of the roof.
Install a right roof panel at the left
front corner of the roof.
3
Install 4 roof panels in the se-
quence and positions shown on pre-
vious page.
Do not fasten the lower
end of the panels to the side wall
angles at this time. Continue weather
stripping the ridge opening. Fasten
roof panel overlaps not used for ridge
cap (roof center). Cover the head of
bolt with 2" (5 cm) piece of weather
stripping tape.
NOTE
Narrow roof panel crimped rib is
overlapped by wide rib of
adjacent panel where possible.
Step 15
X28
●
Parts Needed For
●
Roof Assembly
28
● ●
● ● ●
8468 Right Roof Panel (1)
● ●
● ● ●
8469 Left Roof Panel (2)
● ●
● ● ●
6529 Roof Panel (4)
2
Cut 2 short 2" (5cm) strips off the
roll of weather stripping tape, and
put them aside. Cover the joint at the
peak with weather stripping tape.
Unroll the tape and press it down
over the opening at the ridge as you
install each roof panel. Do not cut the
tape at this time.
NOTE
If roof beam holes do not line up
with the roof panel holes, shift the
building from left to right.
If this does not help, your building
may not be level. Shim the
corners until holes line up.
Do not fasten
at this time
FRONT
Fasten At
Overlap with
Bolt
6529 Roof Panel
Fasten At
Overlap with
Bolt
Screws To Roof Beam
Weather Stripping
Tape Roll
8469 Left Roof Panel STEP
2
STEP
Strips
STEP
Screws To
Roof Beam
1
3
8468 Right
Roof Panel
Cut Weather
Stripping and
Fold Under.
FRONT