Arrow Storage Products MRD108, Руководство пользователя и инструкции по сборке

Страница: 27 / 32

1
Install a left roof panel at the left
rear and right front corner of the roof.
Install a right roof panel at the left
front corner of the roof.
3
Install 2 narrow and 2 wide roof
panels in the sequence and positions
shown on previous page. Do not
fasten the lower end of the panels
to the side wall angles at this time.
Continue weather stripping the ridge
opening.
NOTE
Narrow roof panel crimped rib is
overlapped by wide rib of
adjacent panel where possible.
Step 14
A27 ctr
Parts Needed For
Roof Assembly
8468 Right Roof Panel (1)
8469 Left Roof Panel (2)
7483 Roof Panel (2)
6529 Roof Panel (2)
2
Cut 4 short 2" (5,1 cm) strips off
the roll of weather stripping tape,
and put them aside. Cover the joint at
the peak with weather stripping tape.
Unroll the tape and press it down over
the opening at the ridge as you install
each roof panel. Do not cut the tape
at this time.
NOTE
If roof beam holes do not line up
with the roof panel holes, shift the
building from left to right.
If this does not help, your building
may not be level. Shim the
corners until holes line up.
Do not fasten
at this time
Fasten At
Overlap with
Bolt
Fasten At
Overlap with
Bolt
Screws To
Roof Beam
STEP
STEP
Screws To
Roof Beam
3
8469 Left Roof Panel
7483 Roof Panel
6529 Roof Panel
8468 Right
Roof Panel
Weather Stripping
Tape Roll
7483 Roof Panel
FRONT
6529 Roof Panel
1
STEP
2
(38) (19)
27