!
6.0 General Preparations
Safety Advice
Always ensure that you are using a proper C-Stand, Steel Low Boy Stand or a another
suitable stand made of steel.
Make sure the stand is set up on even ground.
Make sure you are not exposed to strong wind or heavy rain.
Make sure that the yoke of the Docking Bracket is over the longest leg of the stand.
Securing the stand with sand bags greatly reduces the risk of the stand falling
6.1 Setting up the TRINITY Rig
1.
Remove the entire Monitor Bracket from the Center Post.
2.
Use the Post Tool for the following steps.
• Remove the Sled from the Center Post of the artemis system.
• Remove the Top Stage from the Center Post of the artemis system.
3.
Mount the Top Stage to the lower end of the Center Post.
NOTICE
The Bubble is aligned to the back.
CAUTION
Plug in the main cable connector carefully into the socket of the Top Stage when placing it on
the bottom of the post.
CAUTION
Use the Post Tool to ensure that the Docking Ring is fully tighten.
4.
Bring the C-Stand to the lowest position.
5.
Open up the Fine Trim Section to the maximum.
6.
Dock the post on the docking ring above the Fine Trim adjustment
as shown into the Docking Bracket.
17
