30
14.6
Speed
(FIZ motor in Speed Mode)
NOTE
In general, the speed of FIZ motors can
only be adjusted while the motor is
operating in
Speed
mode.
For example, to adjust the speed of
the
Zoom
motor touch:
Menu - FIZ
Selecting
Speed
selection will open a new
touchscreen display with a slider to allow
the operator to set the needed
Speed
for the selected lens motor.
14.7
Speed
(FIZ motors in Position Mode)
NOTE
In
Position
mode, the speed cannot be changed
in general.
Alternatively, you can change the
Ratio
between
the controller and the
Focus
motor.
For example
To cover the entire focus area of a broadcast lens with the OCU-1,
set the
Ratio
for a 1: 1 rotation of the OCU-1 and lens 360° to
+20
.
14.8
Fine trimming the FIZ controller
In addition to speed and ratio, the following parameters can also be set:
Deadband
,
Sensitivity
,
Ramp
and
Ramp Mode
.
Selecting Menu, Controls, FIZ and then
Position
will open a sub menu for each controller.
NOTE
To ensure direct response of the FIZ controller ensure that:
Deadband
set to
0 or max 3
Ramp Start
set to
0
or max 4
Ramp Stop
set to
0
or max 4
Ramp Mode
set to
Constant
FIZ Setup