Mounting and Assembly
25
5
Mounting and Assembly
5.1
Attachment of Accessories
WARNING!
Falling Camera Accessories
If the system is inadequately built up or assembled, it can fall down and cause serious in-
juries and damage to the system or property.
Installation and operation may only be carried out by trained personnel who are familiar with the
system. Observe accident prevention regulations.
Do not place the system on an unstable trolley or hand truck, stand, tripod, bracket, table or any
other unstable support device.
Always place the camera on dedicated support devices.
Secure the system and its accessories against falling and tipping over. Observe the general and
local safety regulations.
When using the system on camera cranes, a suitable safety rope must be used.
Use only accessories approved by ARRI. The use of accessories not approved by ARRI is at
your own risk. Please observe all relevant safety guidelines.
CAUTION!
Improper Mounting of Lenses and Accessories
Mounting the camera on tripods or other support equipment and attachment of accessories
like e.g. lenses, electronic and mechanical accessories poses a crushing hazard for fingers
and/or hands.
Before mounting ARRI accessories or recommended third-party accessories (such as lenses,
mechanical accessories, electronic accessories), read the operating instructions provided by the
manufacturer.
Always use the tools specified by the manufacturer for mounting.
Top Attachment Points
The camera is equipped with two main accessory at-
tachment points (1) on the camera top to attach acces-
sories like
Low Mode Support LMS-4 (K2.0024062)
Universal Adapter Plate UAP-3 (K2.0034179)
Lightweight Camera Handle LCH-1 (K2.0024066)
The third attachment point (2) is used to secure the
Top Extension Bracket TEB-1 (K2.0024062) when
used in combination with LMS-4 or UAP-3.
Use a 3.0 mm Allen/hex key to attach the accessories.
Tighten screws crosswise.