Safety Instructions
20
NOTICE
Open Lens Mount
When no lens or lens cap is attached to the camera, dirt and dust particles may enter the
camera and settle on the sensor cover glass. Particles on the sensor cover glass can later
be visible in the recordings made by the camera.
Place the protective cap on the lens mount, when no lens is attached to the camera
Contact ARRI Service to inspect the camera if undefined spots appear in the image.
NOTICE
Connection of Onboard Monitor
Damage to the SDI driver chip caused by power surge.
Always make sure to plug in the power cable first and then connect the BNC cable. As soon as
the power and BNC cables are connected, you can switch the camera or the accessories on or
off.
Always make sure to disconnect the BNC cable first and then disconnect the power cable.
Only use shielded power cables to power accessories that connect to the camera with a BNC
cable. When only the plus pin connects on a shielded power cable, the shield will act as the
power return and therefore not damage the SDI output.