SixPak Manual rev. 16.1
–
September 12, 2016
Page 4
Array Solutions band decoders, Micro-ham decoders, W9XT, Top Ten Devices and other band
decoders can be used to easily drive the SixPak. We even have a special level converter board
with isolated relays that can be used to drive a SixPak outside remotely located on a tower.
Key Benefits
Six antennas shared by two radios.
Safety interlocked to protect your radios
Saves on hard-line if used on the tower
High isolation between radios to avoid interference
Teflon SO-239, or N connectors for reliability
Extremely low insertion loss
Will work up to 54 MHz
Can be controlled from Automatic band decoders with 12 V DC outputs
SixPak Controller Options
Dual Controllers
SixPak Dual Rotary Controller:
https://www.arraysolutions.com/sixpak-dual-rc
SixPak Dual Push-Button controller:
https://www.arraysolutions.com/sixpak-dual-ctrl
To Use this Push Button Controller
1.
Wire the Radio 1 and Radio 2 relay drivers to the SixPak
2.
Plug in DC power jack to supply 12V DC
3.
If you wish to use it with a Band Decoders (BandMaste IVs recommended) daisy
chain the ShackLan IV cables thru the BandMaster IV and one to the Push Button
