55
*OPC
This command sets the “Operation Complete” bit (bit 0) of the standard event register
after the command is executed.
*PSC { 0 | 1 }
(Power-on status clear.) This command clears the status byte and the standard event
register enable masks when power is turned on (*PSC 1). When *PSC 0 is in effect,
the status byte and standard event register enable masks are not cleared when power is
turned on.
*PSC?
This command queries the power-on status clear setting. The returned parameter is
“0” (*PSC 0) or “1” (*PSC 1).
*SRE <
enable value
>
This command enables bits in the status byte enable register.
*SRE?
This command queries the status byte enable register. The power supply returns a
decimal value which corresponds to the binary-weighted sum of all bits set in the
register.
*STB?
This command queries the status byte summary register. The *STB? command is
similar to a serial poll but it is processed like any other instrument command. The
*STB? command returns the same result as a serial poll but the “Request Service” bit
(bit 6) is not cleared if a serial poll has occurred.
*WAI
This command instructs the power supply to wait for all pending operations to
complete before executing any additional commands over the interface. Used only in
the triggered mode.
SCPI Conformance Information
The SCPI commands relevant to the power supply operation are introduced in detail
in this manual, and most of their usage and formats are in accordance with the
standard SCPI Commands. There are still some commands required by the standard
SCPI commands not being introduced but it is not necessary for the users to know
them.
SCPI Confirmed Commands
The following commands are introduced in this manual:
