www.armytek.com
within 1 minute and the flashlight exits from the Setting Mode
into the standard operation one without saving your selection.
Second Line and General Setting Menu
When in the Second Line, you might set all 5 mode types: the special
signals as well as the stabilized light modes and their brightness.
At first, switch on to the mode requiring setting, and then change it.
Also, you might perform the general settings of the flashlight from
any mode of this Line: change the number of the modes in both lines,
reset the flashlight settings to the factory default ones, select the
brightness stabilization type, change the voltage supply selection,
and set the method of auto memorizing of the last activated mode.
General Setting Menu Control
Setting Menu entry: when the flashlight is on and its head is
loosened it is required to tighten the head (more than for 1
second), then loosen the head relative to body by
¼
turn (within
3 seconds) and switch on/off the flashlight with click. This entry
is developed to prevent the accidental entry in this mode.
Menu indication: when entering the menu item your flashlight
shows its number with the help of indication. For instance, if it
flashes 3 times from low level of brightness to high one, the Item
3 is chosen.
Switching between the Menu options: switch on/off the
flashlight with click.
Menu selection confirmation: tighten/loosen the flashlight head
within 1 second. It enters the selected Menu item for further
setting (or it exits from the Setting Menu into the standard
operation mode if your selection is final). If you do not make your
choice within 1 minute, your flashlight exits from the Setting
Menu into the standard operation mode without saving your
selection.
Item 1. Mode Selection and Setting
Entry: the flashlight will show the Item 1 by flashing for 1 time;
when confirming by tightening/loosening the head, your
flashlight shows 5 available modes through indication with the
pauses between in the following sequence:
l
Strobe
– frequent blinking at the same frequency
l
Firefly
– switching-on to the ultra low mode
l
Beacon
– 1 flash per several seconds
l
SOS
– the light flash according to the Morse code
l
Stabilized light
–
constant bright light
Selection confirmation: tighten/loosen the flashlight head within
1 second while the required choice is activated or the flashlight
pauses after it. If you do not make your choice within 1 minute,
your flashlight exits from the Setting Menu into the standard
operation mode without saving your selection.
l
When choosing the modes Beacon, SOS or Firefly, your
flashlight saves your preferences and changes the Setting
Mode to the standard operation one.
l
When choosing the mode Strobe, your flashlight starts to
change the strobe frequency from 1Hz to 50Hz within 30
seconds.
When the flashlight head is tightened, it pauses
and you might choose the current mode.
The repeated
slight loosening of the head allows keeping on the cycle.
When maximum brightness is reached, your flashlight
starts changing its brightness according to the circle cycle
from zero. The flashlight saves your choice after
confirmation by tightening/loosening the head, and it
changes the Setting Mode to the standard operation one.
l
When choosing the mode Stabilized light, your flashlight
starts to increase the constant brightness of the stabilized
light. It comes though the whole circle cycle within 40
seconds pausing with double blinking at 25%, 50%, 75%
and 100% of brightness.
When the flashlight head is