'
3
51ZUYKRKIZZNOY
FUSH
35*
35*
Ȑ
'[ZUSGZOISUJK
Press to get into automatic mode and LCD displays seven blank data(there
are 100 groups,7 groups each blank.)Press without loosing,enter number until
the cursor shines.Select group by switching .For example,press M without
loosing,then enter 23 until cursor shines.Press M or group data,or
switch or to get M23.If there is only dotted line there,press C to enter data.
And set cutting size 285mm, press or to save,then set next designate data.
The rest can be done in the same manner,After finishing setting,change key to
select 285.0 and press to make paper pusher move to M1 285mm position
automatically .Select , display ,That means the backgauge won’t push
paper or books after cutting.Press once time and display That means
the backgauge will push paper or books automatically after cutting.
3
51
51
FUSH
1)There are three pushing modes in programming paper guillotine.Now
we take 285mm for example to push paper.
Ȑ
3GT[GRSUJK
Manual mode is with priority.As long as rotating the knob with hand,the
mode will be swiched into msnual state anddisplay whatever mode it is in
before.When in divide and automatic mode state,only press to switch into
manual mode automatically.
Ȑ
Rotate the knob clockwise.Backgauge will move in the direction shown by
the arrow ,Backguage move 0.1mm each rotation.It moves quickly if
keep pressing the knob
Ȑ
Rotate the knob anitclockwise.Backguage will move in the direction shown
by the arrow .Backguage move 0.1mm each rotation.It moves quicker
and quicker if you keep pressing the knob
Ȑ
Assuming present backgauge is in 300mm position,it moves 0.1mm eash
rotation until getting the position of 285mm.The crystal display screen show
：
