9
Step 5: Final check
1.
Check voltage of the batteries and ensure they are not excessively discharged. The lowest voltage of batteries
for airplane should not be lower than 9.6v. Otherwise, battery cells are likely to be damaged.
2.
Make sure the inner part of the airplane is clear;
3.
Testing the airplane
Step 1: Preparation
Before proceeding the next steps, please ensure the 433 transmitter and receiver are correctly connected and bound,
then:
1.
Take off the propeller
To prevent yourself and bystanders from being hurt.
2.
Plug off GPS
Otherwise the flight control will automatically search for satellites, which may cause failure of entering OSD.
All operations hereunder are done without GPS. It could be located as per the photo below:
Step 2: Requirement of radio
The functions of radio are varied from different brands. Please refer to relevant instructions on your radio’s manual.
1.
Number of total channels should be equal to or over 6;
2.
Create a new model on your radio.;
3.
No mix mode, disable any mixing options.
4.
One switch of 2 positions is needed. CH5 is the best port for it (as per aforesaid photo about wiring of 433
transmitter)
5.
One switch of 3 positions is needed. CH6 is the best port for it (as per aforesaid photo about wiring of 433
transmitter)
6.
Values of each channel should be equal to or over 100%. The value of channel for throttle should be -110%
or less.
