8
As per the photo: As per the chart:
1 Balancing head of 3s battery; 1). Beware negative pole and positive pole of the battery 12v+ and 12v-
2 Receiver of radio for the power supply of the 433 transmitter;
3 3s battery; 2). Beware negative pole and positive pole of the output portal of
4 Arkbird 433 transmitter transmitter 5v+ and 5v- for the power supply of the radio receiver.
3). Channel mapping:
No.
433 transmitter
Receiver of radio (user supply)
1
CH1
For aileron (roll)
2
CH2
For going up and down (pitch)
3
CH3
For throttle (motor)
4
CH4
For direction (track)
5
CH5
For switches of 2/3 control flaps (excluding CH1-CH4)
6
CH6
For switches of 3 control flaps (excluding CH1-CH5)
4). Please make sure that each part is connected correctly before powering on.
If the 433 transmitter works well, the LED (yellow) will flash fast. If the 433 transmitter does
not receive signal from receiver of radio, the same light will flash slowly.
2.
Binding the 433 System.
Power off the 433 transmitter, then power on airplane;
Constantly press the button (as per the photo) for about 6-10 seconds till the LED light flashes 1 time
every second;
Power on 433 transmitter, then LED will fast flash ;
Binding is finished;
