Ariston NIMBUS AQUASLIM 15 WH, Технические инструкции по установке и обслуживанию

Страница: 43 / 52

EN / 43
Key/Display Operation
The keys of the remote control and touch-screen display perform the same function.
When the unit is switched on, the preset set-point appears on the 3 digits of the display.
The room temperature set-point can range between 16 and 31 °C.
Do not set a temperature that is too low or too high is harmful to health and is an unnecessary
waste of energy.
Power on/off
By pressing the appropriate key, you can switch the device off (standby) or on. The control panel has
its own memory, therefore no settings will be lost in case of shut-down or power outage. The key is
used to activate or deactivate the unit for short periods.
If you plan to keep the device out of service for a prolonged time, remember to deactivate it by
disconnecting the power or removing the power plug.
Not used.
Cooling only mode
When this operating mode is enabled, the device dehumidifies and cools the room.
The temperature can be set between 16 and 31 °C. If the set temperature is lower than the room
temperature, after three minutes (at the most) the cooler-radiator will start running and the device
begins to deliver cold air, continuing to ventilate the room even if the device reaches the set-point.
Ventilation only mode
When you enable this function, the device enable the fan and does not adjust the temperature or the
humidity of the air in the room. The mode allows you to set the fan speed.
Heating only mode
When this operating mode is enabled, the device heats the room.
You can set the temperature between 16 and 31 °C and if the temperature is higher than room
temperature, after three minutes (at the most) the compressor goes off and the appliance begins to
provide heat.
Night comfort key
With the device switched on and the cooling or heating mode selected, pressing this key allows you
to perform multiple functions in order to maximise the quietness of the device, saving on electricity
and optimally adjusting the temperature for night comfort.
In this mode the fan is set to minimum speed.
This function should be activated just before falling asleep.
-
In cooling mode, the set temperature is increased by 1 °C after 1 hour and by 1 °C after 2 hours.
After the second hour, the temperature setting is not altered any more and after 6 more hours the
device shifts to stand-by.
- In heating mode, the set temperature is decreased by 1 °C after 1 hour and by 1 °C after 2 hours.
After the second hour, the temperature setting is not altered any more and after 6 more hours the
device shifts to stand-by.
This function is not available in the dehumidification only, ventilation only and automatic economy
mode, and can be excluded at any time (ideally when you wake up) by pressing the key again.
If you simultaneously set the Timer function, the device switches off after the preset time.
Airflow direction control
By pressing the appropriate key, you can set the constant oscillation of the air flow deflector, in which
case the symbol on the display is on, or lock it in any position.
IMPORTANT: Never force the flow deflector manually to move it. In cooling and dehumidification
mode, the flow deflector’s position is reset every 30 minutes in order to prevent the formation of
dew.