8
1.4 Servicing and Removal of the Gas Valve
1
2
3
4
A
B
C
E
F
D
Setting the minimum and the maximum power of the boiler
1. Check that the supply pressure to the gas valve is a minimum of 20 mbar
for natural gas.
2. To do this, remove the screw “A” (Fig. a).
Fit the pipe of the pressure gauge to the pressure connection of the gas
valve “B”.
When you have completed this operation, replace the screw “A” securely
into its housing to seal off the gas.
3. To check the pressure supplied by the gas valve to the burner, remove the
screw “C” (Fig. b). Fit the pipe of the pressure gauge to the pressure out-
let of the gas valve “D”.
Disconnect the compensation pipe either from the gas valve or from the
sealed chamber.
4. Set the On/Off button to position < I > and the "summer/winter" switch to
the flue test position.
Turn on the hot water tap and allow the hot water tap to run at full rate.
Adjust nut “E” (Fig. c) on the modureg to set the maximum gas pressure
(displayed on the pressure gauge) turn the screw clockwise to increase the
pressure and counter-clockwise to decrease, corresponding to the maxi-
mum power (see table “A” page 8).
5. To set the minimum power, disconnect a supply lead from the modureg
and adjust screw “F” (Fig. d) whilst holding the outer nut.
Turn the screw clockwise to increase the pressure and coun-
ter-clockwise to decrease the pressure (displayed on the
pressure gauge) corresponding to the minimum power (see table “A” page 9).
6. When you have completed the above operations, turn off the
hot water tap, re-connect the supply terminal to the modureg
on the gas valve and replace the cap on the screw of the
modureg.
Setting the maximum heating circuit power
7. To set the maximum heating circuit power, place the
On/Off button to position < I > and the "summer/winter" switch to winter
position.
Turn the knob of the heating thermostat clockwise to maximum;
8. Remove the left hand inspection panel of the P.C.B. and fit a small
cross-head screwdriver in to the right hand potentiometer. Turn clockwise
to increase the pressure or counter-clockwise to reduce the pressure.
Adjust the setting to the required heating pressure value (displayed on the
pressure gauge), as indicated in the diagrams shown in page 9.
9. Turn off the boiler by placing the main switch to the "Off" position.
Setting pressure for soft ignition.
Disconnect the detection electrode connection from the P.C.B. (see fig.
1.13).
Start the boiler and during the ignition sequence adjust the centre poten-
tiometer until the gas pressure reads the required gas pressure as per the
table below.
Once the gas pressure is set turn off the boiler and reconnect the connec-
tion to the P.C.B.
NB.: It may be necessary to reset the flame failure reset a number of times
during this operation.
Recommended pressure for
slow ignition
5 mbar - 1.95 in w.g.
NATURAL GAS (G20)
BUTANE GAS (G30)
PROPANE GAS (G31)
18 mbar - 7.0 in w.g.
19 mbar - 7.4 in w.g.
1.4.1 Setting gas pressures
Fig. a
Fig. b
Fig. c
Fig. d
VG001Aa
VG001Ac
VG001Ab
VG001Ad
TB001A
