10
Anti-cycling
Device
Soft-light
Adjustment
Max Heating
Adjustment
1.4.2 Removing the spark generator
Fig. 1.23
Fig. 1.25
Fig. e
Q
R
1. Disconnect ignition leads “Q” by pulling upwards (see fig.
1.23);
2. Remove the screw “R” (see fig. 1.24) with a Pozidrive No.
2 star tip screwdriver;
3. Remove the spark generator by pulling forwards (see fig.
1.25);
10.Remove the pipe from the pressure gauge and connect screw
“C” to the pressure outlet in order to seal off the gas.
11.Carefully check the pressure outlets for gas leaks (valve inlet
and outlet).
12. Reconnect the compensation tube to the gas valve.
IMPORTANT!
Whenever you disassemble and reassemble the gas connections,
always check for leaks using a soap and water solution.
Setting the anti-cycling device
This appliance is equipped with a potentiometer which delays the
ignition of the heating control and is situated on the P.C.B. (see the
electrical diagrams).
By adjusting the potentiometer, it is possible to change the time
interval between the burner shutting down and its next ignition.
It is preset at 1 minute and can be adjusted from 0 to 2 minutes.
Use this control in particular situations where continuous shutting
down and ignition of the main burner occurs.
Fig. 1.24
FR010A
SM04A
