1
Use
And Care Instructions
SPECIAL FUNCTIONS
Clock programming
• The clock can be reprogrammed at any time except during an active timed function.
• The clock can be displayed in a twelve hour format and valid clock times are from 1:00 to 12:59.
• The clock can be reprogrammed pressing the “Timer” key for 5 seconds, and after, the clock can be adjusted
with the “+” and “-” keys. Colon “:” will flash indicating clock programming mode.
• The user can have minute increments / decrements of 1 minute, but if the user keep pressing the “+”/”-” keys
for more than 1 second, the increments / decrements will be of 5 minutes. During this option the control will
round to the nearest 5 minutes.
• The user can finish on reprogramming the clock pressing the “timer” key.
• After 1 minute of no key pressed the control will accept the programmed clock time and will add one minute
to the set clock.
G
rease filter saturation alarm
• After thirty fan functional hours, the display will show “Grease Filter” if the fan is active. When this icon is
shown in the display, the grease filters installed are required to be washed.
• To reset the grease filter saturation alarm the user must press the “+” key for 5 seconds, after this action the
icon “grease filter” is not display, and the hood has the normal display operation.
Charcoal filter saturation alarm (Recirculating accessories)
• After one hundred and twenty functional hours of the fan, the display will show “Charcoal Filter” if the fan
is active. When this icon flashes on display, the charcoal filters installed are required to be replaced or
reactivated.
• To reset the grease filter saturation indication the user must press the “-” key for 5 seconds, after this time
the icon “charcoal filter” is not display and the hood has the normal display operation.
A
udible signal activation and deactivation
• The audible signals can be activated or deactivated pressing the “Light” key for 5 seconds.
• If the audible signal is activated, a tone must sound and the “Snd” symbol must appear on the display for 2
second.
• If the audible signal is deactivated, the “Snd” symbol must appear on the display for 2 second and no sound
must sound.
C
harcoal filter inclusion and exclusion (Recirculating accessories)
• The charcoal filter inclusion or exclusion can be set by pressing the “-” and “+” keys at the same time for 5
seconds.
• The Inclusion or exclusion of charcoal filter must be selected while the lamps and the motor are OFF.
• When the charcoal has been excluded, the charcoal filter alarm is disabled.
H
eat sensor
•
The control is equipped with a heat sensor that will turn on the blower at second speed if excessive heat
occurs (over 70°C) surrounding the control area.
•
If the blower is OFF or if it is operating at first speed, the blower will be set automatically to second speed.
•
During this state, the user may raise the blower speed to third speed but can not decrease the speed.
•
When the temperature level on the hood drops to normal, the blower will operate in the setting defined by
the user before the alarm occured.
