ARIESAUTOMOTIVE.COM
•
NEED ASSISTANCE?
•
877.287.8634
•
3025183-INS-RB
•
PAGE 3
Step 4
At this time, adjust the running board
to the desired location.
With the running board in position,
it is recommended to tighten all
brackets to the boards first, followed
by the vehicle connections.vv
Tighten all hardware to the
recommended torque specifications
listed in the table on the first page.
Repeat steps 1 through 4
on the passenger side.
Step 5
On the driver side, plug the rear actuator
(red / black) into the running board and
pull the extra wire back into the vehicle.
Plug the LED light wire (brown / tan) into
the LED light and secure it to the mounting
bracket tab with the supplied jam nut.
Once all the wiring is installed, cover the
wires with slit loom for extra protection.
Repeat for the passenger side of the vehicle.
See below for wiring call outs.
Wiring Locations
DS
LED light
Brown / Dark brown
Actuator
Black / Red
PS
LED light
Pink / Brown
Actuator
Black / Red
Step 6
Attach the two wiring harnesses and re-install
the fuse removed during initial wiring process.
