ARIESAUTOMOTIVE.COM
•
NEED ASSISTANCE?
•
877.287.8634
•
3025183-INS-RB
•
PAGE 2
Step 2
With help, carefully place the running board
onto the mounting brackets.
Align the T-rails with the mounting brackets
on the vehicle. Slide the top mounting track on
the board over the top flange on each bracket.
Adjust the T-rails in the lower track of the
board so the studs drop into the slots on the
bottom of each mounting bracket.
Step 1
With the driver-side brackets installed, take the
driver-side running board and insert T-rails into
the slot as shown. Position each T-rail as close
to the mounting bracket location as possible.
Note:
The number of mounting brackets
may vary based on application. Use one
T-rail per bracket.
Step 3
Secure the running board to the front mounting
bracket using one 5/16" OR M8 flat washer and
one 5/16" nylock nut on each T-rail stud.
Note:
5/16" and M8 are interchangeable sizes.
Depending on the hardware supplied with your
brackets you may use either size.
Repeat for the middle mounting bracket.
Before securing the rear mounting bracket,
place an LED light bracket over one of the
T-rail studs, as shown in the third image.
Secure each T-rail stud with one 5/16"
flat washer and one 5/16" nylock nut.
Snug the hardware, but do not fully tighten.
