EN - 6
This product is equipped with an internal
combustion type engine. Do not use unit on
or near any unimproved, forest-covered or
brush-covered land unless exhaust system
is equipped with a spark arrester meeting
applicable local, state or federal laws. A
spark arrester, if it is used, must be
maintained in effective working order by
operator.
Never operate the snow thrower without
good visibility or light. Falling snow, fog, etc.
can reduce vision and cause an accident.
Never operate unit after or during the use of
medication, drugs or alcohol. Safe operation
requires complete and unimpaired attention
at all times.
Never allow anyone to operate this unit
when their alertness or coordination is
impaired.
Do not throw snow any higher than
necessary.
Clearing a Clogged Discharge Chute
Hand contact with the rotating
auger/impeller inside the discharge chute is
the most common cause of injury associated
with snow throwers. Never use your hand to
clean out the discharge chute.
To clear the chute:
1. SHUT THE ENGINE OFF!
2. Wait 10 seconds to be sure the
auger/impeller blades have stopped
rotating.
3. Always use a clean-out tool, not your
hands.
Maintenance and Storage
Secure unit so it will not tip over during
maintenance.
Before cleaning, removing clogs or making
any inspections, repairs, etc., disengage
auger control lever, stop unit and engine,
allow moving parts to stop and hot parts to
cool.
Make sure the equipment is in safe working
condition. Check hardware at frequent
intervals for proper tightness. If components
are worn or damaged, replace with
manufacturer’s recommended parts.
Do not change engine governor settings or
over-speed engine.
Adjust and service as required. All motion of
auger/impeller must stop quickly when
auger control lever is released.
Always maintain unit in safe operating
condition. Damaged or worn out muffler can
cause fire or explosion.
Keep unit free of ice or other debris. Clean
up oil or fuel spills.
Always keep protective structures, guards,
and panels in good repair, in place and
securely fastened. Never modify or remove
safety devices.
Never store the machine with fuel in the fuel
tank inside a building where ignition sources
are present such as hot water heaters,
space heaters or clothes dryers. Allow the
engine to cool before storing in any
enclosure or covering the unit.
Always refer to operator's manual for
important details if the snow thrower is to be
stored for an extended period.
Maintain or replace safety and instruction
labels as necessary.
Run the machine a few minutes after
throwing snow to prevent freeze-up of the
auger/impeller.
Personal Protection
Do not operate the equipment without
wearing adequate winter garments. Avoid
loose fitting clothing that can get caught in
moving parts. Wear footwear that will
improve footing on slippery surfaces.
Wear adequate safety gear, including safety
glasses with side shields, and protective
gloves.
Do not wear loose clothing or jewelry, and tie
back hair that may get caught in rotating
parts.
Protect eyes, face and head from objects
that may be thrown from unit. Wear
appropriate hearing protection.
Slope Operation
Operate the snow thrower on level surfaces.
Stay off slopes and slippery surfaces.
Do not clear snow across the face of slopes;
go up and down. Exercise extreme caution
when operating on slopes. Do not attempt to
clear steep slopes.