EN - 15
See Figure 15.
4. Remove hardware retaining paddles to
center plate and side plates. Discard all
parts.
IMPORTANT:
DO NOT remove center plate.
Install Auger Paddles
1. Install spacers into paddle holes. See
IMPORTANT:
Install new paddles so wear
indicator holes are positioned on the right
side of unit.
2. Secure each paddle to side plates with
four hex bolts, four flat steel washers and
four flange nuts.
3. Secure each paddle to center plate with
two hex bolts and two flange nuts.
4. Torque paddle hardware to
5.6 N•m – 10.2 N•m (50 lb-in – 90 lb-in).
DO NOT overtighten.
5. Rotate auger paddles by hand to ensure
paddles are secure and do not interfere
with housing.
6. Return unit to upright position.
7. Remove slack from auger cable. See
8. Reconnect spark plug wire and turn fuel
valve to the on position.
ADJUST AUGER CABLE
See Figure 18.
1. Stop engine and wait for all moving parts
to stop and for hot parts to cool.
2. Move plastic sleeve up to auger control
lever.
3. Remove cable end from adjustment
bracket.
4. Insert Z-hook into highest adjustment
bracket hole reachable.
5. Wrap cable end around adjustment
bracket.
IMPORTANT:
When auger control lever is
disengaged, there should be slight slack in
cable and no tension.
Figure 15
Figure 16
Figure 17