Ariens GRAVELY, Инструкции по установке, Страница: 4 / 12

EN - 4
Slide wedge back to cylinder and reinstall clevis pin,
washer and hair pin.
a. Remove the cotter pin (# 16) and clevis pin (#
15) from the control lever (# 9).
b. Rotate control lever up to control valve and
reinsert the clevis pin.
c. Insert cotter pin back into clevis pin and spread
ends outward.
d. Install remaining stripper plate.
a. Attach hydraulic hose to draw bar using P-clamp
(# 4), 3/8 x 1" hex bolt (# 19) and hex nut (# 20).
b. Roll unit off of crate bottom.
a. Add ISO 32 hydraulic fluid (# 18) to reservoir.
See owner’s manual.
b. Check engine oil level and add if necessary. See
engine manual.
c. Add fuel and start engine and allow to warm up.
See engine manual and owners manual.
d. Fully extend and retract cylinder 3 or 4 times.
e. Stop engine.
f. Check hydraulic fluid level on dipstick and add
more fluid if necessary.
8.
9.
Install clevis pin, washer and hair pin.
Rotate
lever up.
15, 16
9
10.
11.
WARNING: AVOID INJURY. DO NOT
proceed until operation and safety rules
are fully understood.
Read and understand the entire Owner’s
Manual before proceeding.
19, 20
4