GB - 10
FILLING FUEL TANK
To add fuel to the tank:
1. ALWAYS place unit in an open, well- ventilated
area.
2. Stop engine and allow to cool.
3. Clean fuel cap and surrounding area to prevent
dirt from entering the fuel tank.
4. Remove cap.
IMPORTANT: See engine manual for correct type and
grade of fuel to use.
5. Fill fuel tank to within 1/2 inch (1.27 cm) below
bottom of filler neck. Tank capacity is 4.0 qts
(3.8 liters).
6. Replace fuel cap and tighten.
7. ALWAYS clean up any spilled fuel.
PRE-START
1. Check Engine Air Cleaner Position (Climate
Guard)
IMPORTANT: See Engine Manual for correct
orientation of air cleaner cover prior to starting engine.
2. Check Function of Clutches
Brush must stop quickly when attachment clutch lever
is released.
Wheels must stop quickly when traction drive clutch
lever is released.
If clutches do not engage or disengage properly, adjust
or repair before operation (see Service and
Adjustments).
3. Check Dual Handle Interlock
Without the engine running, press down (engage) both
clutch levers. Release attachment clutch lever.
Attachment clutch should remain engaged until traction
clutch lever is released, then both clutches must
disengage.
If clutches do not engage or disengage properly, adjust
or repair before operation (see Service and
Adjustments).
4. Check Remote Differential
Test the remote differential lock before starting.
Squeeze and hold the remote differential lever to lock
differential so both wheels drive and provide better
traction. Release the remote differential lever to allow
easier steering.
5. Adjust Brush
Adjust brush height and angle before operation. See
Brush Adjustments.
6. Check Engine Fuel and Crankcase Oil
Check and add fuel if required. Check that the engine
crankcase oil is full using dipstick. Refer to Engine
Manual for detailed instructions.
TO STOP IN AN EMERGENCY
Immediately release both control levers to stop unit in
an emergency. Stop engine and wait for all rotating
parts to stop before leaving operator’s position.
STARTING AND SHUT OFF
IMPORTANT: At start-up, allow unit and engine to
adjust to the outside temperature before operating.
Before shut-off, run unit a few minutes to prevent
freeze-up.
NOTE: Try out each control without the engine running
to see how they work and what they do.
Manual Start
1. Make sure that the traction clutch and attachment
clutch levers are fully disengaged.
2. Turn on engine shut-off switch ("I").
3. If engine is cold, apply choke. A warm engine
requires less choking than a cold engine. See
Engine Manual for detailed instructions.
4. Set throttle to proper starting position.
5. Pull rope with a rapid continuous full arm stroke.
Let rope rewind slowly.
IMPORTANT: DO NOT let Starter Handle snap against
Starter.
WARNING: FLAMMABLE FUEL and its
EXPLOSIVE VAPORS can result in death
or serious injury. Handle fuel with extreme
care. ALWAYS use an approved fuel
container. NO Smoking! NO Lighted
Materials! No Open Flames! Allow engine
to cool before any service.
This side out for use ABOVE 32°F
(0°C).
This side out for use BELOW 32°F
(0°C).
WARNING: AVOID INJURY. Read and
understand the entire Safety section
before proceeding.
