Ariens 27-Ton Log Splitter, Руководство пользователя

Страница: 8 / 28

GB - 8
ALWAYS maintain unit in safe operating
condition. Damaged or worn out muffler can
cause fire or explosion.
Disconnect unit from tow vehicle before
using.
Use wheel chocks to prevent movement of
unit during operation.
Logs should be cut with square ends before
placing on splitter.
When placing logs on unit position hands on
sides (bark side) of logs and not on the ends.
Never place hands or any part of the body
between a log and any part of the log splitter.
Do not attempt to stabilize logs with legs or
feet while operating. Moving parts can cut off
or crush body parts.
Do not split more than one log at a time
unless the cylinder has been fully extended
and a second log is needed to complete the
separation of the first log.
Position logs against end plate grips before
operating hydraulic cylinder.
Split logs end to end in the direction of the
grain, not against the grain.
Keep fingers and hands away from cracks in
logs while splitting. These can quickly close
and pinch or crush body parts.
On logs that are not square place the longest
portion of the log closest to the beam and the
most square end against the splitter wedge.
Use only your hand to operate the control
lever.
Tools Required:
• Two 3/4" wrenches or sockets.
• Thin-nosed pliers.
Unpack Unit
Remove unit and all other components from
the shipping container and move onto a level
surface.
Assemble Tongue Assembly
1. Ensure that jack stand is down and in
locked position.
2. Remove rear hex bolt and nut from
frame and retain (see figure 4).
3. Remove front hex bolt and nut retaining
tongue assembly to frame and retain.
4. Position tongue assembly in operating
position on frame.
5. Insert hex bolts through tongue
assembly and frame (see figure 5).
6. Secure hex bolts with hex nuts.
7. Tighten all hardware.
ASSEMBLY
WARNING: AVOID INJURY.
Read and understand the entire
Safety section before proceeding.
CAUTION: DO NOT start engine
until all assembly steps have
been completed.
Figure 4
Remove and
retain hex bolts
and nuts.
Safety
Chain
Tongue
Assembly
Jack
Stand