PiCUS TMS 3 manual
9
www.argus-electronic.de
Stopping a measurement
For stopping a measurement with a PiCUS TMS 3 perform the following steps:
1. Activate BLE in the PiCUS TMS 3 with the magnetic key (a duration of 1 s is sufficient here).
ATTENTION! Wait for the initialisation time of the
communication of approx. 5 s!
2. Start the TMS 3 App or
REFRESH
for an update of the
device list.
This process may take a few seconds.
3. The activated PiCUS TMS 3 is now visible in the device
list.
4. Check sensor status:
MEASURING
5. Clicking on the sensor-box opens the sensor control
menu.
6. Choose
SWITCH OF THE SENSOR
confirm the security query.
7. During the following wait time GPS data is collected (time and position). If the GPS signal is not
available the phone’s internal system time is used as stop time for the measurement.
8. After finishing the stopping procedure, the view changes back to the device list. The sensor is
now no longer listed (has shut itself down).
Additional functions of the TMS 3 App
4.4.1 Live mode
While the sensor is in measurement mode, the live mode shows the highest tilt in the last second. Live
data from all connected sensors can be shown simultaneously.
The live mode has to be activated for the PiCUS TMS 3 to send live measurement data to the mobile
phone.
Proceed as follows:
1. Prerequisite is a running measurement (see
4.2 Starting a measurement
)
2. Every sensor-box in the device list has, while operating in measurement mode, a button on
the right side. These buttons activate the
LIVEMODE
for the associated sensors.
Live mode is
activated.
The PiCUS TMS 3 is
in measuring mode.
Live mode is
turned off.
