Assembly Instructions
10
Step
13
Prepare the left side
Refer to step 1 and, if
required, fit 2 hinge
plates onto the left
side , making sure
that the slot is facing
towards the front edge.
Tap 2 wooden dowels
into the left side as
shown .
Note:
Wooden dowels
must not
stick out from
the edge by more than
10mm or they may
damage other panels.
Screw 2 metal dowels
into the left side .
Note:
Tighten metal
dowels up fully against
the panels.
Insert 2 large locking
nuts into the left side
. .
Note:
The arrow on the
locking nut
must
point
towards the hole in the
edge of the panel.
Adjust the doors if
needed
a:
Before adjusting the
doors, use a spirit level
to check the base (or
top) of the unit is level,
front-to-back and
side-to-side in the 3
positions shown.
Use suitable packing
pieces (not supplied) to
make the unit level
BEFORE making any
adjustment to the hinges,
as shown.
b:
Height adjustment.
Loosen screws A on
hinge plates and move
door up or down as
required.
Retighten screw A.
c:
Forward and Back
adjustment
.
Loosen screw B on hinge
plate and move door in
or out as required.
Retighten screw B.
d:
Sideways
adjustment
.
To move door ‘out’
loosen screw C.
To move door ‘in’ tighten
screw C.
b:
c:
d:
a:
A
A
B
C
