Finished
front edge
Assembly Instructions
7
Step
7
Prepare the left side
Refer to step 1 and, if
required, fit 2 hinge
plates onto the left
side , making sure
that the slot is facing
towards the front edge.
Tap 2 wooden dowels
into the left side as
shown .
Note:
Wooden dowels
must not
stick out from
the edge by more than
10mm or they may
damage other panels.
Screw 2 metal dowels
into the left side .
Note:
Tighten metal
dowels up fully against
the panels.
Insert 2 large locking
nuts into the left side
. .
Note:
The arrow on the
locking nut
must
point
towards the hole in the
edge of the panel.
Step
8
Fit the top
Push the top onto
the left side and right
side .
Use a screwdriver to
tighten the 4 large
locking nuts fitted to
the left side and right
side .
Note:
Turn the large
locking nuts as far as
they will go - more than
1/2 a turn.
3
1
2
C
1
2
C
Fit the back
a:
Square up the unit by
making sure that
measurement
x to x
equals y to y.
b:
Place the back
onto the unit.
Nail around the
outside edges of the
back .
Note:
Nails should be
spaced about 150mm
apart.
Stand the unit up for
the next step.
7
D
The measurement from top corner X to bottom corner X must be
equal to the measurement from top corner Y to bottom corner Y
a:
7
3
2
1
b:
D
y
y
x
x
7
Warning:
The
unit is heavy.
Lift with care.
