Argo Frontier 600 6x6, Руководство оператора

Страница: 42 / 76

34
To install the Drive Belt:
If this procedure is not carried out as described, the edge
of the fixed face may cut or damage the drive belt.
1. Position the belt around the driver clutch first.
2. Ease the belt over the edge of the fixed face on the driven
clutch and at the same time, turn the inside, movable face
clockwise.
Drive Belt alignment and tension are pre-set at the factory
and are not adjustable. They are critical for proper operation
of the drive system. Return the vehicle to an ARGO dealer if
rapid belt wear occurs.
7.2.2 CLUTCH MAINTENANCE
Disassembly and repair of the driver and driven clutch requires
special tools. Return the vehicle to an authorized ARGO dealer
if the clutch units need servicing. The following indicates that
clutch service might be required:
•
a drop in vehicle performance
•
the clutch does not shift smoothly
•
the clutch sticks during vehicle operation
•
the drive belt wears rapidly
•
the vehicle vibrates severely during operation
•
the vehicle does not accelerate when the engine speed is
increased with the transmission in gear
•
transmission will not shift smoothly into gear at engine
idle.
Clutch Inspection
Inspect the nylon sliders every 50 hours. The nylon sliders are
mounted in the driven clutch moveable pulley. (Figure 7-7).
When the clutch shifts, the cam moves on the nylon sliders.
Replace the nylon sliders before there is aluminum to alu-
minum contact between the cam and the movable pulley.
Driven clutch disassembly is required to replace the nylon
sliders properly. Return the vehicle to an ARGO dealer for
service.
SECTION 7
MAINTENANCE INFORMATION
4. After adjustment, check belt level by placing a drive
belt between the sheaves. Belt position should be
anywhere from flush with the top of the sheaves, to
1/10" above. Re-tighten jam nuts and torque to 60-75
in. lbs. (7.5 +/- 1 Nm)
Figure 7-5. Turn the adjustment set screw.
To Remove the Drive Belt
The Invance Driven Clutch (transmission clutch), is
manufactured with a 6mm x 1.0 threaded hole in the clutch
face. This hole is provided to assist in spreading the driven
clutch pulleys apart by threading a 6mm x 1.0 thread bolt in
through the face. This bolt should be a least 2” in length with
full thread. Spreading the pulleys allows for easy removal
and installation of the 127-159 drive belt. Figure 7-6.
Figure 7-6. Drive belt removal.