Argo Frontier 600 6x6, Руководство оператора

Страница: 34 / 76

26
SECTION 6
OIL, FILTER AND LUBRICATION INFORMATION
6.3.2 Fuel Filter - Kohler EFI
Frontier models of the ARGO are equipped with an
in-line fuel filter. Kohler powered EFI models have
one fuel filter, located in the engine compartment lo-
cated near the battery. (Part No. 25 050 13 ). Figure 6-6.
Figure 6-6. Frontier Kohler EFI fuel filter location.
EFI Kohler engines - Fuel system under high pressure.
6.3.3 Fuel Filter - Briggs and Stratton
Briggs and Stratton has one fuel inline fuel filter located in
the engine compartment located near the fuel impulse pump.
(ARGO Part No. 125-64). Figure 6-6b
Figure 6-6b.Frontier Briggs fuel filter location.
6.3.4 Oil Filter
Change the oil filter when the oil is changed.
Part No. 12 050 01 - Command Pro EFI engines.
Part No. 842921 - Briggs and Stratton Vanguard engines.
Before installing the new filter, lubricate the rubber filter
gasket with clean engine oil. Screw the filter on by hand until
the gasket contacts filter adapter. Tighten 1/2 to 3/4 turn more.
Start and run engine to check for oil leaks. Stop engine and
re-check oil level. Add oil if required.
6.4 LUBRICATION INFORMATION
6.4.1 General
The following parts and components require regularly sched-
uled lubrication to prevent premature wear and replacement.
1. Idler Chain 2. Drive Chains
3. Bearings
Use the recommended lubricants listed in this section and
carefully observe the recommended lubrication intervals.
6.4.2 Clutch Lubrication
No lubrication is required for either the driven clutch or driver
clutch. They are designed to run dry. If lubricant is used, use
of the vehicle will attract dirt and cause damage to the clutch
components. Contamination by dust and dirt can cause poor
performance, premature wear or failure.
Only qualified personnel should perform installation, main -
tenance, adjustments and repair operations on the variable
speed transmission system
.
A complete service of the clutch units is required after
every 250 hours of operation. To perform this procedure, the
clutches must be disassembled. Special tools are required to
disassemble the clutch units. We recommend that you return
your vehicle to an authorized ARGO dealer to have the clutch
units serviced.
6.4.3 Drive Chain Lubrication
Your ARGO vehicle is equipped with roller chains to each
axle. Lubricate the chains every 10 hours with Aerosol Chain
Lube (ARGO brand Part No. 130-101), or more frequently in
dirty or wet conditions.
After every 100 hours of operation, or for extended periods
of storage, remove all the drive chains from the vehicle and
clean them thoroughly in a suitable solvent, i.e. degreaser.
See WARNING following page.
Never use gasoline as a cleaning solvent. Gasoline is
extremely flammable and can explode if ignited, causing
serious personal injury.
Allow the chains to dry thoroughly, re-lubricate generously
with ARGO Chain Lube and re-install.
Refer to Section 7.2.3 of this manual for drive chain removal
and re-installation instructions.