31
SECTION 7
MAINTENANCE INFORMATION
1. Pull the left steering lever back.
2. While holding the lever, lift the spring loaded brake lever
until it contacts the pin in the steering lever.
3. Release the steering lever, allowing the holding brake le-
ver to lock the left brake on.
4. If the steering lever grip is approximately 18 cm (7") from
the dash, the holding brake system is correctly adjusted.
5. If the distance from the dash is greater, refer to Section
7.3.4 STEERING LEVER ADJUSTMENT to properly
set the left lever.
7.4 HYDRAULIC BRAKES - VANGUARD2,
BIGFOOT, RESPONSE and CONQUEST
7.4.1 GENERAL
Although the hydraulic brake system is self adjusting, the
following require periodic attention:
7.3.4 STEERING LEVER ADJUSTMENT
Adjust
the steering levers when:
• steering levers travel more than 18 cm (7") from the dash
to apply the brakes;
• the levers are not parallel when the brakes are applied; or
• the brake adjustment nuts have been removed during the
removal of the firewall.
To adjust the steering levers, tighten both brake adjustment
nuts (refer to Figure 7-20) clockwise using a 1/2" deep socket
and ratchet until the levers are both 18 cm (7") from the
dash. DO NOT OVER TIGHTEN.
7.3.5 HOLDING BRAKE ADJUSTMENT
Although the holding brake system has been factory adjusted,
it should be checked after every 25 operating hours to ensure
the correct adjustment.
The use of an improperly adjusted holding brake is a se-
rious safety hazard, and could lead to vehicle damage or
personal injury.
WARNING
Figure 7-24. Hydraulic brake cylinder and fluid level
Do not overfill the brake master cylinders. Fluid level
must be at the top of the view window. Overfilling can
cause seal damage.
Use only SILICONE - DOT5 BRAKE FLUID. Other brake
fluid may not be compatible with ARGO brake compo-
nents and operating temperatures. Use of other fluids will
void the warranty.
7.4.2 BRAKE FLUID LEVEL
After every 50 hours of operation, check the brake fluid level
through the side mounted view window in each master cyl-
inder (Figure 7-24). The fluid level must be above the top of
the view window.
If the brake fluid is below this level:
1. Thoroughly clean the master cylinder cover and surround-
ing area.
2. Remove the two screws, lift off the cover and the gasket.
3. Add only fresh clean SILICONE - DOT 5 BRAKE FLUID
(ARGO Part No. 126-19) to the correct level.
4. Replace the cover on each master cylinder, making sure
the rubber gaskets are properly seated before tightening
the cover screws.
CAUTION
Содержание 6x6 Bigfoot
Страница 5: ...NOTES III...
Страница 6: ...NOTES IV...
Страница 13: ...3 SECTION 1 GENERAL INFORMATION 1 6 IDENTIFICATION AND LOCATION OF CONTROLS...