Subject to change · V 4.06.19 · EN
Page 18
www.argo-hytos.com
7.4
Charging process
Please note the following procedure to ensure correct charging.
1. Open the cover of the device.
2. Connect the charger connector of the device to the power supply
3. Connect the power supply to the supply network (100-240 VAC), then a plug symbol is shown on the display.
4. To ensure a full charge, the device must be connected to the power cable for at least 1 h.
5. When a charging state of 100 % is reached, the charging circuit automatically terminates the charging.
Please note that the device cannot be switched off while charging due to technical reasons.
When operating without pump, the runtime is min. 24 hours, with pump operation the runtime reduces depending on the
viscosity of the medium.
