ARGENTO AB-EP-Y20, Руководство пользователя

Страница: 16 / 61

15
Enabling walk assist mode
Select a walk assist level equal to or greater than 1 and then press the lever to enable the walk assist function, which enables
electric motor power up to a speed of 6km/h.
Disable the function by releasing the lever.
CAUTION
The walk assist mode must be used in compliance with the regulations in force in the country of use and is only allowed when
pushing the electrically power assisted cycle by walking alongside the bicycle and holding the handlebar grips firmly with
both hands.
DANGER
It is strictly prohibited to enable the walk assist mode when you are sitting on the saddle of the electrically power assisted
cycle to avoid the danger of injury and the risk of damaging the electrical components of the bike.
Switching the light on/off
Press the – button for 3 seconds to switch the front light on and off.
Viewing data (ODO - TRIP)
Available distance data will be displayed alternately and automatically in the following sequence: ODO (total distance data
display) - TRIP (partial distance data display).
Partial distance data (TRIP) can be reset by simultaneously pressing the + and - buttons for a duration of 2 seconds.
Indicator light for residual battery charge
The battery charge level is shown on the display screen as a number of dashes between 0 and 5.
If there are 5 dashes, it means that the battery is charged to the maximum percentage defined and detected instantly.
Less dashes are shown to indicate a decrease in the battery charge level available and subsequent autonomy.
The level of the battery charging indicator may fluctuate depending on how the electrically power assisted cycle is being
used, for example, when going up a slope, the level displayed can drop rapidly as there is a much higher battery consumption.
The individual dashes indicate the specific battery charge range detected at the time and do not necessarily indicated a
percentage of the residual autonomy.
Malfunction indicator light
If a malfunction of the product’s electrical and/or electronic system is detected, the "!" warning light appears on the display
screen and the corresponding Error Code is simultaneously displayed.
Refer to the following summary table to find the description of the fault and the corresponding action to be taken to allow the
product to be restored to correct operation, either by you alone and/or by contacting the after-sales service for support:
www.argentobike.it/assistenza/