arf SLICK540 120E, Инструкция по эксплуатации, Страница: 24 / 46

2
．
The SLICK is supplied with a high quality set of pull-pull cables and ball-links.
3
．
Locate the pull-pull cable set, threaded couplers, brass swaging tubes, and ball-links. If the cable is one
long piece, cut it into two equal length pieces. Thread one end of the one cable through a brass tube and
then through one of the threaded couplers. Run the cable back through the brass tube and then loop it back
through a second time. Using a set of crimping pliers, place three crimps just tight enough not to cut the
brass tube but enough to securely hold the wire in place. Cut off the excess cable with wire cutters. Wick
thin CA into the brass tube to help hold the cable secure. Repeat for the other cable.
4
．
Thread the couplers about half way into the ball links of the rudder. Hint: remove the ball links from
the rudder horn first to make this step easier and then re-install once the couplers are threaded on. Feed the
loose end of each cable into the cable slots at the rear of the fuselage and feed them forward towards the
servo mount location. A coat hanger with a hook on the end can be useful here if you can’t reach the cable.