arf SLICK540 120E, Инструкция по эксплуатации, Страница: 12 / 46

 Thick and Thin CA adhesives
 30 minute Epoxy
 Isopropyl alcohol
 Ruler or tape measure
 Blue thread-lock or equivalent
Note: As with all kits, it’s a good idea to read all the instructions and study the parts before you begin
construction. Handle the parts of this kit with care so you do not damage any of the structure or covering.
Inspect all the parts for any shipping damage and report any issues to as soon as you can. Make sure you have
a flat and sturdy workbench and follow all safety advice for the tools and adhesives you plan to use.
AIRCRAFT COVERING
1. With all ARFs, varying temperatures and storage delays can cause covering material to loosen over time
and transportation. recommends lightly going over all the covering with a covering iron set at medium
temperatures. Be sure to use a soft cover over your iron so you do not scratch the covering surface.
Be sure you go over all seams and edges of the covering to assure it is secure to the airframe and other
covering. Be careful not to apply too much heat or you may cause bubbles or damage to the covering.
A heat gun may also be used along with a soft cotton cloth to shrink and adhere the covering. Again,
be extremely careful when using a heat gun.
2. Be sure to seal any exposed wood with a thin coating of epoxy to prevent engine oil from soaking
in. This is especially important around the engine compartment and servo openings with exposed
areas.
3. Some modelers prefer to seal the hinge gaps using strips of appropriate covering or clear trim tape. We
have found this to be helpful with models intended for higher speed flight or models with unusually
large hinge gaps. aircraft utilize a very tight double beveled hinge line and do not normally require this
step. Sealing the hinge gaps is therefore left as an option for the modeler.
Please verify the accessories before assemble:
New Fiber glass servo horns: 8 single horns for ailerons and elevators. 2 dual horns for rudder.
There is a layer of protection film on the horns. Please remove the film as shown following picture.