Ares RECON FPV, Руководство пользователя

Страница: 18 / 25

18
1. Open the rear battery cover of the quadcopter and insert the larger Quad
LiPo into the fuselage. Connect the LiPo’s two pin plug to the socket of
the quadcopter making sure to align the slots for correct polarity. Tuck
the lead neatly behind the LiPo and close the battery cover.
2. When the battery is connected the LED lights will flash. Place the Recon
on a level surface to enable the on-board gyro to be properly calibrated.
3. Switch the transmitter ON by pressing the power button. The quad’s LEDs
will stop flashing and emit a solid light indicating that the Recon and the
transmitter are paired. DO NOT arm the throttle at this stage.
4. To re-calibrate the gyros, place the left-hand transmitter stick into the
bottom left corner of the gimbal and the right-hand transmitter stick into
the bottom right-hand corner of the gimbal. The quad’s LED lights will
flash once more then emit a solid light, indicating that the calibration
process is complete.
5. You can now arm the throttle by pushing the throttle stick forward to its
stop, then back to its lowest point.
Propeller Identification
If at any point you damage one of your Recon’s propellers it’s imperative
that the replacement prop is matched with the correct motor, as shown in
the Quadcopter Details section on page 8 of this instruction manual. The
identification numbers of the propellers can be found on the underside near
the center (root section) of the blade. Note that since the blades are a simple
push fit on the motor shafts, a gentle tug will easily remove them.