Full manual available to download from: www.Ares-RC.com
13
Power ON your transmitter, centre all
trims, set low throttle, then connect a
fully charged 1000mAh 2S LiPo to the
ESC’s HCT lead. On connection of the
battery two short beeps and one long
beep will be heard, indicating that the
ESC is armed and operational. Secure
the battery directly behind the servos
using hook and loop tape.
14
Connect the elevator and rudder
clevises to the outer hole of e ach
control horn noting that you may
have to screw the clevis in or out
to ensure that the control surface
remains in the neutral position.
15
Connect the aileron clevises to
the outer hole of each control horn
noting that you may have to screw
the clevis in or out to ensure that
the control surface remains in the
neutral position.
16
Make sure the control
surfaces operate in the
correct direction noting the
following recommended control
movements:
Aileron: 6mm each way
Elevator: 8mm each way
Rudder: 15mm each way
