QUICK-START GUIDE
Full manual available to download from: www.Ares-RC.com
10
Remove the magnetic canopy hatch
and locate the rudder, elevator and
aileron servo leads, plus the throttle
lead from the ESC. Pair your chosen
transmitter and receiver, then
connect the leads to the respective
rudder, elevator, aileron and throttle
sockets on the Rx.
11
Use hook and loop tape to attach
the receiver beneath the wing seat,
far enough back to allow room for
the battery which is positioned
directly behind the rudder and
elevator servos. Stow the servo
leads beneath the receiver.
12
To ensure absolute safety during
the set-up process it is essential
that you now remove the propeller.
Using a Phillips screwdriver and
a 10mm spanner, remove the
spinner cone followed by the
propeller hub / blades.
Dry fit the fin then, using the wing as a
guide, check it for vertical alignment.
When happy with the fit, apply a
generous but even spread of glue to
the mating surfaces of both fin and
tailplane and glue the fin in position
using masking tape to hold it level.
Leave the adhesive to cure.
9
