BIOS CONFIGURATION
24
The Host_BIOS setup manager message remains on your screen
for about five seconds, giving you time to start the setup menu by
pressing
Tab
or
F6
. If you do not wish to enter setup menu, press
ESC
to skip configuration immediately. When activated, the Host_
BIOS setup manager appears showing a selection dialog box listing
the SAS host adapters that are installed in the system. The legend
at the bottom of the screen shows you what keys are enabled for
the screens.
Areca Technology Corporation SAS Controller Setup V1.00, (2008/12/15)
ArrowKey Or AZ:Move Cursor, Enter: Select, **** Press F10(Tab) to Reboot****
Select An Adapter To Configure
#2 (049/14/4) I/O=AF948362h
#1 (004/00/0) I/O=FD9FF000h
Fnc: Indicates the PCI Function assigned by the system BIOS to
the selected adapter (range 0 - 7 decimal)
I/O: Indicates the I/O port address assigned by the system BIOS
to an adapter
IRQ: Indicates the interrupt (IRQ) channel of the selected adapter
BIOS: Indicates the BIOS address assigned by the system BIOS to
the selected address
The adapters scan and up to
eight
devices' information and total
connected device count during system bootup. But,the adapters
can only boot up from the first
eight
devices on the screen.The
operating system device driver will recognize up to 128 end-point
devices. The bootable devices need to be put on the first
eight
devices connected to the controller.
Note:
It is normal when it appears “No BIOS disk found. Areca SAS
controller BIOS not installed!” during system boot. It rep-
resents that there was no bootable SAS device such as SAS
HDD found after SAS BIOS detected SAS devices. Thus, above
message is shown and this will not affect system operation.
Содержание ARC-1330 Series
Страница 5: ......
