Original User Manual
–
A
REBO
S Upright Vacuum Cleaner Eco
7
•
For this, press the button and push the brush to the end of the nozzle. It must engage.
•
Press the button again to unlock the brush.
Assembly the Wall Holder
Inserting the Plug of the Power Supply Unit
If you want to use the wall holder also as the charging station, attach the plug of the power supply
unit first. Refer to the illustrations (A to C) on page 21.
NOTE:
•
Turn the plug at the metal end, not at the cable. Use a pliers if necessary.
•
There is an opening at the rear of the wall holder. You can the plug additionally with a
finger through this opening.
1.
Set the plug of the power supply unit with the flattened side into the wall holder. (Fig. A)
2.
Turn the plug of the power supply unit by 90 °. It must sit solidly in the holder and sliding no
longer shall be possible. (Fig. B)
3.
Fix the cable in the cable guide. (Fig. C)
Fastening the Wall Holder
WARNING: Make sure beforehand whether there are cables in the wall which could be damaged!
CAUTION: Place the wall holder so that the appliance is not exposed to direct sunlight or other
heat sources.
NOTE: A power outlet must be near.
1.
Measure the height for the wall holder. Hold the vacuum cleaner against the wall with the
suction pipe and the floor nozzle installed.
2.
Hold the wall holder against the wall as shown on page 21.
Mark 2 drill holes.
3.
Drill the holes and insert the wall plugs into the wall.
4.
Insert the screws through the holes of the wall holder.
5.
Tighten the screws with a screwdriver hand-tight.
Charging the Battery
1. Turn off the device.
2. Connect the power supply unit with the connection socket (5). If you
have prepared the wall holder as a charging station, suspend the appliance
from the wall holder.
3. Connect the mains adapter to a certified wall socket.
Charge the device for approx. 5 hours before first-time use.
