User’s Manual
–
A
REBO
S Infrared heater 2500 W with remote control
12
7.
Cleaning, maintenance and service
7.1 Maintenance
•
It is very important to perform careful and regular maintenance of the device in accordance
with the recommendations made in this manual so that it can run efficiently for a long time.
In case there is a problem with your heater, please contact a qualified specialist.
•
Before maintenance or cleaning work, the device must be disconnected from the electricity
grid.
•
Once a month, a check should be made as to whether there is any potential contamination.
•
If the infrared heater is dirty, careful cleaning should be performed. See point Cleaning.
•
Of course, the above checks are always dependent on how much pollution is present at the
respective location of the device.
•
The reflector and the tube should also be visually inspected for deformation or damage. In
the case of conspicuous deformations or glass breakage, please contact a qualified specialist
to take the necessary steps.
•
The power cord and plug must also be checked while the unit is being cleaned. If the power
cord or plug shows any deformation or damage, please contact a qualified professional
immediately.
7.2 Cleaning
•
Attention! Regular and thorough cleaning ensures longevity and optimum performance.
•
The unit must be switched off and the power cord disconnected from the circuit. In addition,
it should cool sufficiently before cleaning.
•
If the tube is dirty, clean it with dry compressed air without removing the protective grid.
Do not attempt to clean the device using solvents or other flammable liquids. (This can cause
an electric shock or fire). Also, do not use a steam cleaner.
•
Clean the outside surface of the unit with a soft cotton cloth, microfiber cloth or a soft brush.
•
Do not use corrosive cleaning agents or solvents to clean the infrared heater. These can
damage the surface and components.
•
Turn on the unit again when it is completely dry and clean.
•
If the device is to be stored for longer, cover it with a protective cover to avoid dust on the
device and sensitive points. Always disconnect the power plug and switch off the power!
7.3 Exemplary cleaning of the reflector
•
Disconnect the power adapter cable from the electrical outlet.
•
Remove the heater from the safety bar.
•
Remove hood (6) as shown in the picture
•
Take out the front grid wire through the inlets on the frame using a slotted screwdriver.
