Area Imager IG610/BT, Руководство по настройке

Страница: 76 / 196

67
Chapter 7 Symbologies
Introduction
This chapter describes symbology features and provides the programming bar
codes for selecting these features.
The device is shipped with the settings shown in the Symbology Default Table
If the default values suit requirements, programming is not necessary.
There are two ways to change a parameter value:
y Scan the appropriate bar codes in this guide. These new values
replace the standard default values in memory.
y For SSI and USB SNAPI hosts, send a “parameter send” command
from the host system. Hexadecimal parameter numbers are shown
in this chapter below the parameter title, and options are shown in
parenthesis beneath the accompanying bar codes. See the
Simple
Serial Interface (SSI) Programmer’s Guide for detailed instructions
for changing parameter values using this method.
Note: Most computer monitors allow scanning the bar codes directly on the
screen. When scanning from the screen, be sure to set the document
magnification to a level where the bar code can be seen clearly, and bars
and/or spaces are not merging.
To return all features to default values, scan the Set Default Parameter bar
code. Throughout the programming bar code menus, default values are
framed.