Area Imager IG610/BT, Руководство по настройке

Страница: 24 / 196

15
SNAPSHOT MODE
Use Snapshot Mode to capture a high-quality image and transmit it to the host.
To temporarily enter this mode scan the Snapshot Mode bar code. While in this
mode the decoder blinks the orange LED at 1-second intervals
to indicate it is
not in standard operating (decode) mode.
In Snapshot Mode, the decoder turns on the laser aiming pattern to highlight
the area to be captured in the image. The next trigger event instructs the
decoder to capture a high quality image and transmit it to the host. A short time
may pass (less than 2 seconds) between when the trigger is activated and the
image is captured as the decoder adjusts to the lighting conditions. Hold the
decoder steady until the image is captured, denoted by a single beep.
If a trigger event is not activated within the Snapshot Mode Timeout period, the
device returns to Decode Mode. Use
Snapshot Mode Timeout to adjust this
timeout period. The default timeout period is 30 seconds.
To disable the laser aiming pattern during Snapshot Mode, see Snapshot
Aiming Pattern .
Use Video View Finder to enable Snapshot with Viewfinder Mode. In this mode
the decoder behaves as a video camera until the trigger is active, at which time
a Snapshot is performed as described above.
Snapshot Mode