Mode
Description
Values
0
Time mode.
This is the normal mode and displays the time. It is the
normal start up mode of the clock. If you do nothing. The clock is in
this mode.
In this mode a short press cycles through the values given in “Time
Display Mode”, but always returns to the standard time display after
5 seconds.
1
Set minutes.
Each short press will advance the minute. The
minutes roll over back to 0 ffter reaching 59 minutes. Each time you
set the minute, the seconds is reset to 0.
2
Set Hours.
Each short press will advance the hour. The hours roll
over back to zero after reaching 12 or 24 (depending on the 12/24
hours mode).
3
Set Day.
Each short press will advance the day. The day roll over
back to one after reaching the maximum number of days in the
month.
4
Set Month.
Each short press will advance the month. The month
roll over back to zero after reaching 12.
5
Set Year.
Each short press will advance the year. The year roll over
back to 2015 after reaching 2099.
6
Fade Speed Slower
. Each short press will make the fade speed
between digits slower.
Default: 50
Max: 200
Min: 20
7
Fade Speed Faster
. Each short press will make the fade speed
between digits faster.
Default: 50
Max: 200
Min: 20
8
HV Generator Frequency Higher.
This controls the internal
frequency of the HV generator. The lower the number, the higher
the frequency of the HV generation. Normally you will not have to
adjust this, but with some tubes, adjusting it can stop “flickering” in
the filaments.
Before leaving the clock for long periods with a new setting, check
that IRF740 MOSFET is not running too hot.
Default: 200
Max: 400
Min: 100
9
HV Generator Frequency Lower.
This controls the internal
frequency of the HV generator. The higher the number, the lower
the frequency of the HV generation. Normally you will not have to
adjust this, but with some tubes, adjusting it can stop “flickering” in
the filaments.
Before leaving the clock for long periods with a new setting, check
that IRF740 MOSFET is not running too hot.
Default: 200
Max: 400
Min: 100
10
Scroll-back Speed Slower.
Each short press will make the “scroll-
back” speed slower.
Default: 4
Max: 40
Min: 1
11
Scroll-back Speed Faster.
Each short press will make the “scroll-
back” speed faster.
Default: 4
Max: 40
Min: 1
12
12 or 24 hour time.
The hours are displayed in 12 or 24 hour
mode.
“1” = 12 hour
“0” = 24 hour
13
Blank leading “0”.
Blank out the leading “0” from single digit hours. “1” = blank
“0” = don't blank
Содержание Nixie Clock v6
