Arduino Nixie Clock v6, Руководство по эксплуатации

Страница: 19 / 24

Anode Control Circuit:
Parts List:
OK1 EL817
OK2 EL817
OK3 EL817
OK4 EL817
OK5 EL817
OK6 EL817
R1 1k
R2 1k
R3 1k
R12 1k
R13 1k
R14 1k
R4 2.7k
R5 2.7k
R6 2.7k
R15 2.7k
R16 2.7k
R17 2.7k
S24 SOCKET 24
SV3 CONN_ANODE
This circuit controls passing the HV to the anodes of the tubes. The micro-controller multiplexes the
anodes by turning each of them on it turn.
Notes:
•
The Opto-Isolators fit into the 24 pin socket snugly. Be careful to put them in the right way round.
The dot denotes pin 1 and should be on the side closest to the micro-controller. All 6 should fit
perfectly into the 24 pin socket.
•
The Opto-Isolators are socketed because they are sensitive to heat and are easily destroyed if you
apply too much heat to them. Putting them in a socket means that we don't run the risk of
destroying them.
Hint: Putting the resistors in
A trick that can speed assembly up is to
use a piece of normal sticky tape to hold
things in place while you solder them.
This makes is easier to solder and gives a
better result.
Place the components, and then
temporarily tape them into place.
Using tape to hold resistors in place