Stingray
™
Model
Page 10
GetEskimo.com
GetEskimo.com
800-345-6007
®
SERviCE, tROuBLESHOOtiNG ANd
REPAiR
SERviCE iNFORMAtiON
At Ardisam, we build quality and durability into the design of our
products; but no amount of careful design by us, and careful main-
tenance by you, can guarantee a repair-free life for your auger. Most
repairs will be minor, and easily fixed by following the suggestions
in the troubleshooting guide in this section.
The guide will help you pinpoint the causes of common problems
and identify remedies.
For more complicated repairs, you may want to rely on your retailer,
an authorized mechanic or Ardisam, Inc. (contact your retailer for
a list of authorized mechanics in your area). A parts catalog is
included in this section.
We will always be glad to answer any questions you have, or help
you find suitable assistance. To order parts or inquire about war-
ranty, call or write us at the address found below, under the section
ordering repair parts.
iCE POiNt REPLACEMENt
1. Remove blade protector and both blades.
2. Remove nut and retaining bolt from point.
3. Using a locking pliers, grasp point and pull out. If holder doesn’t
come out with the point, remove with pliers.
4. With locking pliers, push in new point and holder aligning bolt
hole in point with holes in auger shaft.
dO NOt damage end of
point.
NOTE: When installing holder in auger shaft, edges of
holder may shave off.
5. Insert retaining bolt and tighten with nut.
6. Re-attach both blades and put blade protector back on.
ORdERiNG REPAiR PARtS
Parts can be obtained from the store where your auger was pur-
chased or direct from the factory. To order from the factory, call,
write or order online @ www.ardisam.com:
Ardisam, inc.
1360 First Avenue, Cumberland, Wisconsin 548
1-800-345-6007 • 1-715-8-415
E-mail: [email protected]
Please include the following information with your order:
1. Part numbers
2. Part description
3. Quantity
4. Model number and serial number
CAutiON
!
AvOid iNjuRY! AuGER BLAdES ANd POiNt ARE
ExtREMELY SHARP. uSE CAutiON WHEN RE-
MOviNG & REPLACiNG.
PRACtiCE SAFEtY At ALL tiMES. ENGiNE MuSt
BE tuRNEd OFF ANd ALLOWEd tO COOL, ANd
SPARk PLuG WiRE MuSt BE diSCONNECtEd
BEFORE AttEMPtiNG ANY MAiNtENANCE OR
REPAiR.
