Ardisam Earthquake E43WC, Руководство оператора и взрывные схемы запчастей

Страница: 12 / 16

page 12
ASSEMBLY INSTRUCTIONS ANd pARTS ExpLOSIONS
E43WC Model
800-45-6007
TROUBLEShOOTING
pROBLEM pOSSIBLE CAUSE REMEdY/ACTION
Engine will not start 1. Power switch off 1. Flip switch to ON position
2. Spark plug wire disconnected 2. Connect spark plug wire to spark plug
3. Out of fuel 3. Refuel
4. Spark plug wet, faulty or improperly
gapped 4. Clean, replace or gap spark plug
5. Throttle control not held open 5. Hold throttle control open when pulling recoil
handle
6. Fuel line hose not positioned in bot-
tom of gas tank 6. Push fuel line down into fuel in gas tank
Engine runs rough, floods during
operation 1. Dirty air filter 1. Clean or replace air filter
2. Choke partially engaged 2. Turn off choke
3. Carburetor out of adjustment 3. Call factory
Engine is hard to start 1. Stale fuel 1. Drain old fuel and replace with fresh.
Use gas stabilizer at end of season
2. Spark plug wire loose 2. Make sure spark wire is securely attached to
spark plug
3. Dirty carburetor 3. Clean carburetor, use gas stabilizer, new gas can
4. Throttle control not held open 4. Prime unit 3 more times, then hold throttle open
when pulling recoil handle
Engine misses or lacks power 1. Clogged gas tank 1. Remove and clean gas tank
2. Clogged air filter 2. Clean or replace air filter
3. Carburetor out of adjustment or bad 3. Call factory
4. Spark plug wet, faulty or improperly
gapped 4. Clean, replace or gap spark plug
Engine runs, then quits 1. Gas cap not venting 1. Clean or replace gas cap
2. Plugged fuel filter 2. Clean or replace fuel filter
3. Carburetor out of adjustment or bad 3. Call factory
Engine revs too high 1. Carburetor out of adjustment 1. Call factory
Power drill turns at idle 1. Idle speed too high 1. Adjust idle speed lower
2. Broken clutch spring 2. Replace spring
Drill bit turns, but has no power 1. Choke on 1. Turn off choke after engine is running
2. Carburetor out of adjustment 2. Call factory
3. Broken transmission 3. Call factory
4. Worn clutch shoes 4. Replace clutch shoes and spring
5. Worn engine lower seat 5. Call factory
Drill bit cuts slowly 1. Dull bit 1. Buy new drill bit, or have bit sharpened
Contact service provider if above remedies fail at 800-345-6007.