ARDES AR4U140A, Инструкция по эксплуатации

Страница: 13 / 56

13
Maintenance
Disconnect the plug from the socket and let the appliance cool down well
before cleaning it.
The control unit must be cleaned with a soft, slightly damp cloth.
Do not use substances, liquids or excessively dampened cloths because
any infiltrations could damage the appliance beyond repair.
NEVER IMMERSE THE CONTROL UNIT IN WATER.
The heating panel can be washed. Before washing, remove the control
unit and follow the instructions below which are also provided on the
appliance (see WARNINGS section).
Do not dry-clean or use chemical solvents. They might damage the over
blanket and make it unsafe to use.
Do not wash the panel too frequently as it may get damaged.
Do not store or use the device before it is completely dry.
Instructions for use
- Lay the underblanket between the sheet and the mattress.
- Insert the connector of the cable into the connector of the underblanket.
To remove the controller, lift the locking tab up with your finger and pull the plug
directly out. Do not pull the controller cable and
do not try and pull the controller plug out without
lifting the locking tab as you will damage the
socket.
- Do not place the control under the pillow or
under the blankets when it is switched on.
- Insert the plug into the wall socket.
- The control on the cable has a switch with positions 0-1-2-3-0:
Position 0 = OFF
Position 1 = lower temperature (for continous use)
Position 2 = medium temperature (for pre-heating)
Position 3 = maximum temperature (for pre-heating)
- Switch on the underblanket about an hour before going to bed and select position
2 or 3 on the control.
Keep the underblanket covered.
- WARNING: do not go to bed when the control unit is set to position 2 or 3 to
avoid burns on the skin.
- Before going to bed, set the control unit to position 0; if you wish to hold the right
warm during the night, select position 1 on the control.
For the sake of safety, never open the pad or the control: there are no
parts inside that require servicing.
Do not place the control unit near sources of heat. Do not cover the
control unit or place it on top of the appliance while it is in use.