6-8
REMOVING AXLE HOUSING
1. Secure the ATV on a support stand to elevate the
rear wheels.
2. Remove two cap screws securing the brake cali-
per to the axle housing; then lift the caliper off
the disc.
KM207
3. Remove drive chain, wheels, hubs, spacers, and
axle as necessary (see Removing Rear Hub/
Drive Axle in this sub-section).
NOTE: Do not remove more components than
necessary to perform the intended service. The
axle housing will separate from the swing arm with
all components attached if necessary.
4. Remove the four cap screws (A) securing the
axle housing to the swing arm; then remove the
axle housing.
KM217B
KM212A
CLEANING AND INSPECTING
NOTE: Always clean and inspect the drive axle
components to determine if any service or replace-
ment is necessary. Replace all components that
show signs of wear or damage.
1. Using a clean towel, wipe away any oil or
grease.
2. Inspect bearings for smooth operation.
3. Inspect seals for tears, cracks, or deterioration.
4. Inspect splines on axle for damage or wear.
5. Inspect threads on end of axle for damage or
stripped threads.
6. Inspect axle for straightness by rolling it on a
flat surface and checking for wobble.
7. Inspect axle housing for dents or warpage that
might interfere with bearing bore or alignment.
INSTALLING BEARINGS AND
SEALS
1. Using a plastic mallet and bearing driver or
appropriate size socket, carefully install the first
bearing into the axle housing.
KM226
! WARNING
Make sure the ATV is solidly supported on the sup-
port stand to avoid injury.
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
