4-8
9. Remove the two cap screws securing the gas tank;
then lift the gas tank and secure it out of the way.
MD2393
10. Remove the gas hoses from the fuel valve noting
where each one is attached.
MD1865
NOTE: Mark the gas hoses for assembling pur-
poses.
MD1848
CLEANING AND INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Clean all gas tank components with parts-clean-
ing solvent.
2. Inspect all hoses for cracks or leaks.
3. Inspect gas tank cap and tank for leaks, holes,
and damaged threads.
INSTALLING
1. Place the gas tank into position on the frame;
then install the gas hoses to the fuel valve on the
frame according to the tags made during remov-
ing.
MD2394
2. Install and tighten the gas tank cap screws to
specifications (see Section 10).
NOTE: Do not over-tighten the cap screws secur-
ing the gas tank.
MD2393
3. Install the front fender panel with the eight wash-
ers, four Phillips-head cap screws, and six nuts
and tighten to specifications (see Section 10).
NOTE: Do not over-tighten the cap screws and
nuts securing the front fender panel.
4. Install the gas tank cap.
5. Install the handlebar aligning the pins in the
lower clamps with the locating holes in the bot-
tom of the handlebar. Place the top clamps into
position; then tighten the cap screws to specifi-
cations (see Section 10).
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
